Table of Contents
Advertisement
1. Hitch pin
2. Clevis
•
Raise or lower the hitch clevis to the position
approximately level with the tow vehicle hitch.
•
Secure the clevis to the hitch with the bolts and
locknuts previously removed.
Note: Make sure that the sweeper is parallel with
the ground.
6. Connect the sweeper clevis hitch to the tow vehicle
hitch with the hitch pin and hairpin cotter.
7. Remove the spring pin, rotate the jack and up to the
storage position and install the spring pin.
7
Routing and Securing the
Hydraulic Hoses and Wiring
Harness
Parts needed for this procedure:
8
Cable tie
Procedure
1. Route the hydraulic hoses and wiring harness through
the hose guides to the front of the hitch tongue
10).
Figure 9
3. Hairpin cotter
1. Hydraulic hoses and wiring
harness
2. Secure the hydraulic hoses and wiring harness as shown
in
Figure 11
1. Cable tie (6)
1. Cable tie (2)
(Figure
13
Figure 10
2. Hose guide
and
Figure
12.
Figure 11
Front View
Figure 12
Rear View
Advertisement
Table of Contents
