Specifications; Dimensions And Weights; Attachments/Accessories - Toro 07068 Operator's Manual

Diagnostic Light
The diagnostic light (Figure
and indicates machine fault codes. After you turn the key
to the R position, the diagnostic light will illuminate for
UN
5 seconds, turn off for 5 seconds, and then begin flashing
3 times a second until you push a button on the handheld
remote. If the light turns on for 5 seconds and then starts
blinking 10 times a second (with or without a 5 second pause)
there is a fault with the machine; refer to
Codes (page 31).
Note: The diagnostic light illuminates when a button is
pushed on the handheld remote.
Note: If you have a button depressed on the handheld
remote when you start the machine, the light will not flash 3
times a second after it turns off for 5 seconds.
Figure 18
1. Diagnostic light

Specifications

Note: Specifications and design are subject to change
without notice.

Dimensions and Weights

Width
Height
Dump height clearance
Length
Empty weight
Gross vehicle weight (GVW)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
18) is located on the front cover
Checking Fault
221 cm (87 inches)
202 cm (79-1/2 inches)
173 cm (68 inches)
Hopper lowered -
173 cm (68 inches)
Hopper raised - 229-249
cm (90-98 inches)
680 kg (1500 lb)
1588 kg (3500 lb)
18