Maintenance; Lubrication; Oil Sweeper Jack - Toro 07050 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine
from the normal operating position.
Important Refer to your engine operator's manual for
additional maintenance procedures.

Lubrication

The Rake–O–Vac has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
Lubricate bearings after every 30 hours of operation or
whenever machine is washed with water. Bearings and
bushings must be lubricated daily when operating
conditions are extremely dusty and dirty. Dusty and dirty
operating conditions could cause dirt to get into the
bearings and bushings, resulting in accelerated wear. The
grease fittings that must be lubricated are the gauge wheel
bearings (2) (Fig. 14); reel shaft bearings (2) (Fig. 14);
impeller shaft bearings (2) (Fig. 15); Jackshaft bearings (2)
(Fig. 16) left and right trailing arms (1 ea.) (Fig. 16).
1. Wipe grease fittings clean so foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe up excess grease.
Figure 14

Oil Sweeper Jack

Sweeper jack must be oiled after every 50 hours of
operation.
15
Figure 15
Figure 16
Figure 17