Advertisement
Engine I/O Screen
To access this screen push button 2 on the I/O screen.
This screen displays engine information.
Figure 65
1. Engine speed (rpm)
2. Engine oil pressure
3. Air filter indicator
4. Engine coolant temp
Engine speed (rpm): displays, in steps of 100, the
engine speed (rpm).
Engine oil pressure: displays the engine oil icon .
Air filter: the air filter icon is green unless the filter is
plugged then the indicator is red.
Engine temperature: displays the engine coolant
temperature. The temperature drops to 40°F when
the engine is off.
Battery voltage: displays the battery voltage. If the
engine is off, the voltage is measured by the Toro
controller.
Hydraulic-fluid filter: the hydraulic fluid filter icon is
green unless the filter is plugged then the indicator
is red.
Hydraulic-fluid temperature: displays the hydraulic
fluid temperature.
Hydraulic-fluid level is low: the icon is red when the
hydraulic fluid level is low
g237125
5. Battery voltage
6. Hydraulic fluid filter
7. Hydraulic fluid temp
8. Hydraulic fluid level is low
Cam Arm I/O and Calibration
Screen
To access this screen push button 3 on the I/O screen.
Use this screen to calibrate the cam assembly.
1.
Push button 3 to toggle the calibration on and off.
2.
Push the up and down buttons on the monitor
to select the load position and the pipe-row
position.
3.
Push the OK button 2 times on the desired
position to save the calibration.
The voltage on the bottom indicates the cam raw
sensor voltage. The voltages range from 1.0 to 4.0 V.
Any voltage higher or lower indicates either sensor
failure or incorrect calibration.
The other voltages are the calibrated voltages.
21
Figure 66
Figure 67
g238451
g238452
Advertisement
