Related Manuals for Toro 22472
Summary of Contents for Toro 22472
- Page 1 Form No. 3420-724 Rev A Trench Filler Compact Tool Carrier Model No. 22472—Serial No. 402000000 and Up *3420-724* A Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
The trench filler is an attachment designed for use on Important calls attention to special mechanical Toro compact utility loaders to fill trenches dug by a information and Note emphasizes general information trencher with loose soil left by the trenching process. -
Page 3: Safety
Slope Safety Safety • Operate the machine up and down slopes with the heavy end of the machine uphill. Weight DANGER distribution changes with attachments. An empty attachment makes the rear of the machine the There may be buried utility lines in the work heavy end, and a full attachment makes the area. -
Page 4: Trench Filler Safety
Trench Filler Safety • Stay in the operator’s position behind the control panel while operating the trench filler. • Do not overload the machine capacity by attempting to backfill too fast. • Disengage power to the auger/impeller when the trench filler is transported or not in use. Maintenance and Storage Safety •... -
Page 5: Product Overview
Authorized Service Dealer or authorized Toro hydraulic connections and fittings are tight distributor or go to www.Toro.com for a list of all before applying pressure to the hydraulic approved attachments and accessories. -
Page 6: Filling A Trench
CAUTION Hydraulic couplers, hydraulic lines/valves, and hydraulic fluid may be hot. If you contact hot components, you may be burned. • Wear gloves when operating the hydraulic couplers. • Allow the machine to cool before touching hydraulic components. g259524 • Do not touch hydraulic fluid spills. Figure 4 2. -
Page 7: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Grease the auger bearing. Every 200 hours • Paint chipped surfaces. Before storage • Adjust the skids. Yearly or before storage CAUTION If you leave the key in the switch, someone could accidently start the engine and seriously injure you or other bystanders. -
Page 8: Storage
Storage Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. Check the condition of the teeth. Turn or replace any worn or damaged teeth. Check and tighten all bolts, nuts, and screws. Repair or replace any damaged or worn part. Ensure that all hydraulic couplers are connected together to prevent contamination of the hydraulic system. -
Page 9: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action The attachment does not operate. 1. A hydraulic coupler is not completely 1. Check and tighten all couplers. connected. 2. A hydraulic coupler is damaged. 2. Check the couplers and replace any that are damaged. 3. - Page 10 Notes:...
- Page 11 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
- Page 12 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.