Advertisement
Quick Links
Work Light Kit
RT1200 Trencher
Model No. 25464
Model No. 25464E
This product contains a chemical or chemicals known to the State of California to
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Wiring harness
Work light
Routing the Wiring Harness
1. Connect the 4-pin connector of the wiring harness to
the 4-socket connector of the machine harness under
the dashboard (Figure 1).
1. 4-pin connector
2. Move the harness down and to the left from under the
dashboard.
3. Route the harness along the kick-plate panel and the
steering-console panel, and secure the harness with the
magnetic tie-mount wraps (Figure 2).
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Figure 1
2. 4-socket connector
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
1
Route the wiring harness.
4
Install the work lights.
1. Steering-console panel
2. Magnetic tie-mount wraps
4. Route the harness along the inside of the ROPS-post
tube, and secure the harness with the magnetic
tie-mount wraps (Figure 3).
Form No. 3378-114 Rev A
Installation Instructions
Use
Figure 2
3. Wiring harness
4. Kick-plate panel
Original Instructions (EN)
All Rights Reserved *3378-114* A
Printed in the USA
Advertisement
Related Manuals for Toro 25464
Summary of Contents for Toro 25464
- Page 1 Form No. 3378-114 Rev A Work Light Kit RT1200 Trencher Model No. 25464 Model No. 25464E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Figure 3 Figure 5 3. Wiring harness 1. ROPS-post tube 1. Front ROPS light-cover 2. 2-socket connectors 2. Magnetic tie-mount wraps plate 5. Route the two 2-socket connectors on the wiring 7. Route the wiring harness along the inside of the ROPS harness through the front ROPS-plate holes (Figure 4).
- Page 3 3. Remove the 4 hex-head screws and the 2 cover plates from the rear ROPS light-cover plate (Figure 10). Note: Discard the 4 hex-head screws and the 2 cover plates. Figure 7 1. Rear ROPS light-cover 2. 2-socket connectors plate Figure 10 1.
- Page 4 Operation 2. Insert the new light-bulb assembly at the horizontal position, and turn the knob clockwise 1/4 turn back to the original, vertical position (Figure 14). Operating the Work Lights Important: Do not touch the light bulb during assembly, as this will shorten the life of the light Press button number 1 on the main display screen to turn the bulb.