Advertisement
Figure 62
Mud Selected
Information (I/O) Screens
Joystick I/O and Calibration
Screen
Joystick I/O Screen
Push button 1 on the I/O screen to access the Joystick
I/O screen.
Figure 63
•
The rotary voltage ranges from 0.0 to 8.5 V and
be present for either make (upper icon) or break
(lower icon) as the selected rotary joystick is
moved.
•
The carriage indicates a range from 0.0 to 10.0
volts in the joystick selected direction for thrust or
pullback.
•
The lower left icon indicates if the left joystick is
calibrated properly.
•
The lower right icon indicates if the right joystick is
calibrated properly.
Calibrating the Joysticks
Use this screen to check the calibration of the
joysticks. Refer to
(page 24)
to calibrate the travel pendant.
The red dot is in the center of the targets shows the
movement of the left and right joysticks. If the red dot
does not reach ±10,000, see your Authorized Service
Dealer to service or replace your joystick.
g288872
g237131
20
Calibrating the Travel Pendant
Figure 64
g238476
Advertisement
