Replacing An Ibat - Huawei iBattery 3.0 User Manual

iBattery 3.0
User Manual


Step 2 Label each cable and remove the cables from the iBOX panel.
Step 3 Remove the iBOX.
1.
2.
Step 4 Install a new iBOX.
1.
2.
Step 5 Connect the cables to the new iBOX based on the recorded information.
Step 6 Set iBOX parameters and perform networking.
----End

8.2.2 Replacing an iBAT




Step 1 On the iBOX WebUI, choose Monitoring > iBOX System > Running Control > Net Join
Config, select Replace an iBAT from the Operation Type drop-down list box.
Figure 8-1 Net Join Config
Issue 07 (2019-12-30)
If the iBOX is damaged, hold down the networking switches on all the iBATs managed by
the iBOX to clear present network parameters.
If the iBOX is not damaged, hold down the iBOX networking switch to clear present
network parameters.
Remove the iBOX from the fastener.
Record the iBOX DIP switch address.
In the scenario where the iBOX connects to the NetEco, skip this step because DIP switch setting is not
required.
Set the DIP switch for the iBOX based on the recorded information.
In the scenario where the iBOX connects to the NetEco, skip this step because DIP switch setting is not
required.
Mount the iBOX onto the fastener.
The iBAT needs to be replaced.
A spare iBAT of the same model is available and functional.
An iBAT needs to be replaced when it is faulty or fails in communication. If multiple
iBATs need to be replaced, replace them in ascending order of the corresponding battery
numbers (range 1–300).
Copyright © Huawei Technologies Co., Ltd.
8 Maintenance
73