Setting Ibat Blinking - Huawei iBattery 3.0 User Manual

iBattery 3.0
User Manual
Switching iBAT Numbers
Figure 5-26 Switching iBAT numbers
Switch No.1: Indicates the switching number 1 corresponding to the operation type Switch
iBAT No.
Switch No.2: Indicates the switching number 2 corresponding to the operation type Switch
iBAT No.
Example: There are three iBATs in the network and they are numbered 1, 2, and 3. Choose
Switch iBAT No., set Switch No.1 to 2, and set Switch No.2 to 3. After the operation, the
iBAT numbers 2 and 3 are switched.
Figure 5-27 Schematic diagram

5.7 Setting iBAT Blinking

On the iBOX WebUI, choose Monitoring > iBOX System > Running Control > iBAT
Blink Control to control iBAT blinking.



The iBAT starts blinking after the time specified by Switch on delay time. If Switch on
delay time is set to 0, the iBAT starts blinking immediately.
Issue 07 (2019-12-30)
Blink in sequence:
− When the Start No. and the End No. are the same, the iBAT of this number will
blink.
When the Start No. and the End No. are different, the iBATs from the Start No. to
−
the End No. will blink in sequence.
Blink concurrently: The Start No. and the End No. do not need to be entered. All
iBATs under the iBOX will blink at the same time.
Stop All Blinking: The Start No. and the End No. do not need to be entered. All iBATs
under the iBOX will stop blinking at the same time.
Copyright © Huawei Technologies Co., Ltd.
5 System Commissioning
62