Parallel Networking - Huawei iBattery 3.0 User Manual

Hide thumbs Also See for iBattery 3.0:

Table of Contents

iBattery 3.0

User Manual

Figure 5-17 iBOX

(1) Networking switch

Step 2 Hold down the iBAT networking switch for 2 seconds. When the RUN/ALM indicator turns

from steady red to blinking green at short intervals, and finally to blinking green at long

intervals, the iBAT connects to the iBOX network.

Step 3 Perform networking operations on the next iBAT only after networking for the previous iBAT

is successful. Repeat

Step 4 Hold down the networking switch on the iBOX for 2 seconds. When the RF_Z indicator on

the iBOX turns from blinking green at super short intervals to blinking green at long intervals,

the networking is complete.

Step 5 (Optional) If multiple iBOXs are cascaded, repeat

other iBOXs and iBATs.

----End

5.5.2 Parallel Networking

Prerequisites

Before networking, ensure that all the iBOXs and iBATs have no network parameters, that is,

the RF_Z indicator on the iBOX is steady green and the RUN/ALM indicator on the iBAT is

steady red.

Issue 07 (2019-12-30)



It is recommended that iBATs be networked from the positive battery string terminal according to

the battery cable connection sequence.



The sequence of connecting the iBAT to the iBOX determines the battery number.

Step 2

After the networking is complete, if the ALM indicator on the iBOX is steady on, the number of devices

online is smaller than the value of iBAT number of iBOX. Check that iBAT number of iBOX is set to

a correct value and that the iBATs are successfully networked (The RUN/ALM indicator is blinking

green at long intervals.).

(2) ALM indicator

to add other iBATs to the iBOX network.

Step 1

5 System Commissioning

(3) RF_Z indicator

Step 4

to perform networking for

Table of Contents