Table of Contents
Advertisement
Set FMC Clocks
Select the FMC interface tab with the target FMC card, and then select the tab with the FMC
card part number (XM101, XM104, XM105, or XM107). Each tab has options to set the clocks
on available clock sources. Enter the frequency in MHz and click Set SI570 or Set SI5368 to
program the clock. The example shown in the following figure sets the SI570 clock to 200 MHz
on an XM104 card connected to JA3.
EEPROM Data Tab
The ZCU1285 System Controller includes an EEPROM that is used to store board information.
The information entered into the Board Information window that appears when the SCUI is
launched (see the SCUI Board Information Window in
Interface) can be stored to the EEPROM using the EEPROM Data tab. The EEPROM data can
also be read using this tab (see the following figure).
UG1348 (v1.0) July 16, 2019
ZCU1285 Board User Guide
Figure 44: Set VADJ
Connecting the System Controller User
Appendix E: System Controller
www.xilinx.com
Send Feedback
79
Advertisement
Table of Contents
