Xilinx ZCU1285 User Manual page 22

Xilinx
System Controller
XC7Z010-CLG225
1.8V
Bank 34 (1.8V)
USB-JTAG
Module
MICRO-B
USB Conn.
JTAG
Conn.
PROGRAM Pushbutton
Pressing the PROGRAM pushbutton SW7 (callout 44,
asserts the active-Low program pin of the RFSoC.
DONE LED
The DONE LED DS17 (callout 45,
the DONE pin of the RFSoC. When the DONE pin is High, DS17 lights up, indicating the RFSoC
is successfully configured.
INIT LED
The dual-color INIT LED DS3 (callout 45,
RFSoC initialization status. During RFSoC initialization the INIT LED illuminates red. When
RFSoC initialization has completed, the LED illuminates green.
STATUS LED
The STATUS LED DS39 (callout 45,
lockdown state. When the PS_ERROR_STATUS pin is High, DS39 lights up.
UG1348 (v1.0) July 16, 2019
ZCU1285 Board User Guide
Figure 8: JTAG Chain
VCCO_MIO
DUT_TDI
3.3V
1.8V
Figure 2: Board Component
Figure 2: Board Component
Figure 2: Board Component
Chapter 1: ZCU1285 Board Features and Operation
TMS_0
TDO_0
VCCO_MIO
2:1
TDI_0
MUX
FMC3_TDO
FMC1 FMC2
Connector Connector
(not populated) (VCCO_HP)
FMC2_TDI
Figure 2: Board Component
Locations) indicates the state of
Locations) indicates the
Locations) indicates a secure
Send Feedback
Xilinx
Zynq
UltraScale+
RFSoC
Bank 503 (VCCO_MIO)
FMC3
Connector
(VCCO_HD)
FMC3_TDI
X22890-060719
Locations)
www.xilinx.com
22