Nokia 7302 Basics, Management And Oam Manual page 85

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
(2 of 2)
Sample output:
A:ALA-12>monitor# nt-a:sfp:1 interval 5 repeat 3 absolute
============================================================================
Monitor statistics for nt-a:sfp:1
============================================================================
----------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
----------------------------------------------------------------------------
Octets
Packets
Errors
----------------------------------------------------------------------------
At time t = 5 sec (Mode: Absolute)
----------------------------------------------------------------------------
Octets
Packets
Errors
----------------------------------------------------------------------------
At time t = 10 sec (Mode: Absolute)
----------------------------------------------------------------------------
Octets
Packets
Errors
----------------------------------------------------------------------------
At time t = 15 sec (Mode: Absolute)
----------------------------------------------------------------------------
Octets
Issue: 10
Item Description
Parameters port port-id — Specify up to 5 port IDs.
The port can be either a network port (nwport-id) or an LT port (ltport-id). The syntax is:
•
nwport-id: <slot-address>:<port-type>:<port-num>
•
slot-address - nt | nt-a | nt-b | ntio-1
•
port-type - sfp | xfp | vp | eth | ieee1588 | AI
•
port-num - port-number
•
ltport-id: lt:<rack>/<shelf>/<slot>
•
lt - keyword
•
rack - number identifying the rack
•
shelf - number identifying the shelf
•
slot - number identifying the slot
interval seconds — Configures the interval for each display in seconds.
Default: 10 seconds
Values: 5 — 60
repeat repeat — Configures how many times the command is repeated.
Default: 10
Values: 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
3HH-11982-AAAA-TQZZA
Input
0
39
0
0
39
0
0
39
0
0
Monitor Commands
Output
0
175
0
0
175
0
0
175
0
0
85