"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
4.4.3.13
Table 85
4.4.4
4.4.4.1
Table 86
Issue: 10
send
send command
Item
Description
Syntax
send option-number
no send
Context
configure>system>security>keychain>tcp-option-number
Description
This command configures the TCP option number accepted in TCP packets sent.
The no form of this command returns the number to the default value.
Default
254
Parameters
option-number — Specifies an enumerated integer that indicates the TCP option number to be
used in the TCP header.
Values: 253, 254, 253&254
Show Commands
cpu-filter ip-filter
cpu-filter ip-filter command
Item
Description
Syntax
cpu-filter ip-filter [entry entry-id]
Context
show>system>security
Description
This command displays a single filter or a summary of all filters. In the case that entryId is not
specified, the output consists of a list of all CPU filters.
It has support for drop/forward counters. But it counts both control-plane and data-traffic due
to a limitation on hardware, while a specified action is only applied to control-plane traffic. So
these counters are not accurate. But if it needs to be reset for fresh monitor of any control-plane
traffic, this can be done by specifying shut/no shut on ip-filter so that the counters on all ipv4
entries will be reset.
Parameters
entry-id — Specifies the CPU filter policy ID number.
Values: 1 — 65535
3HH-11982-AAAA-TQZZA
Security
75