Nokia 7302 Basics, Management And Oam Manual page 204

Ethernet Connection Fault Management
Table 239
(1 of 2)
204
Y1731 proactive loss session – show field Descriptions
Label Description
Domain Displays the domain of the Y1731 proactive session.
Association Displays the association of the Y1731 proactive session.
Mep Displays the Maintenance association End Point of the Y1731 proactive session.
Session Displays the session id of the Y1731 proactive session.
Test type Type of the Y1731 proactive session. This could be single-ended-loss or two-way-slm.
Admin status Displays the admin status. (Enabled or disabled).
Priority Displays the priority of the Y1731 proactive session.
Period The value of period specifies the time to wait between the transmission of one OAM
request and the next for this Y1731 proactive session.
Peer Mac Addr Displays target unicast MAC address for the Y1731 proactive session.
Measurement-period Displays the measurement interval of the Y1731 proactive session.
Data TLV size Displays the data size of the two-way-SLM Y1731 proactive session.
Interval-status The object indicates the validity of the corresponding PM data. It is set to valid when the
PM data is complete and valid and set to invalid when the PM data is incomplete or
invalid.
Remote Mep Id The value of this object indicates the MEP Identifier of the remote node corresponding
to the peer mac address from which the Synthetic Loss Measurement Reply (SLR) is
received. This object is valid only for two-way-SLM. For single-end-Loss, the value of
this object is not-applicable (65535).
Test Id The value of this object indicates the test id used in the SLM packet. This object is valid
only for two-way-SLM. For Single-End-Loss, the value of this object is not-applicable
(0).
Elapsed-time The amount of time, measured in seconds, that has elapsed since the beginning of the
interval.
Measured-time The amount of time, measured in seconds that statistics for this entry have been
actually counted for the interval. This value will be the same as the elapsed duration
except in a situation where performance monitoring data could not be collected for this
test for some reason.
Valid-Intervals The number of previous 15 min intervals for which valid data was collected for this test.
PDU Sent The object indicates the number of PDUs sent.
PDU Received The object indicates the number of PDUs received.
PDU Discarded This object indicates the number of SLR/LMR PDUs discarded by this MEP. This will
be increment for every invalid SLR/LMR received from the Peer.
UnAcknowledged The value of this object is the accumulated number of SLM frames that are
unacknowledged within the test duration of 15 minutes.This object is valid only if the
value for two-way-slm.
Total Tx The value of Tx Near end is the accumulated number of frames transmitted at the local
service endpoint of this MEP(Tx FCf), and within the loss test duration of 15 Minutes.
Near end/Far End
The value of Tx Far end is the accumulated number of frames transmitted at the far-end
service endpoint(TxFcb), and within the loss test duration of 15 Minutes.
3HH-11982-AAAA-TQZZA
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Issue: 10