Period; Measurement-Period; Table 219 Period Command; Table 220 Measurement-Period Command - Nokia 7302 Basics, Management And Oam Manual

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
(2 of 2)
8.12.1.14
Table 219
8.12.1.15
Table 220
(1 of 2)
Issue: 10
Item Description
Default 7
Parameters priority — <0,1,2...7>

period

period command
Item Description
Syntax period period
Context configure>eth-cfm>y1731pm>domain
Description The value of period specifies the time to wait between the transmission of one OAM request
and the next. This parameter can be set only when admin status is set to disabled. The
applicability, range, and default value of this object vary with type, as described below.
The no form of the command reverts the value to the default.
Default two-way-slm — 1
two-way-delay — 1
single-end-loss — 60
Parameters two-way-slm (SLM) — 1...10
two-way-delay (DM) — 1...10
single-end-loss (LM) — 60...300

measurement-period

measurement-period command
Item Description
Syntax measurement-period period
Context configure>eth-cfm>y1731pm>domain
3HH-11982-AAAA-TQZZA
Ethernet Connection Fault Management
189