Panasonic PV500 User Manual page 402

When using Individual trigger in "Use-Defined" execution
mode
Send
% S ?
? = 0 – 9 (Block No. to execute)
aa = 0 – 15:
Specifying a camera to capture an image
Specifies a value in decimal notation of 4-bit
data which specifying cameras; Bit 0 =
camera 0, Bit 1 = camera 1, Bit 2 = camera 2,
Bit 3 = camera 3
Bit3
-
Camera 3
Receive % S
Error (ERROR 0 signal = ON)
% S
Error code
200
201
202
203
Example: Starts an inspection specifying camera 1 and block No.9.
Send
Receive
Stop in continuous inspection, stop in execution of detect
trigger
% S BCC(76) CR
Send
No response
Receive
400
, a a BCC CR
Bit 2 Bit 1
- -
Camera Camera Camera
2 1
$ BCC(52) CR
! Error code (3-digit)
Operation is stopped
• "Camera Trigger" in "Camera" is set to "Individual".
• Execution mode is NOT "User-Defined" in PV500.
• The specified block is invalid. (The number which does not/ cannot exist
was specified.)
• The 2nd to 4th command specified different block from of the 1st to 3rd
command.
• The specified camera number is invalid.
- No camera is connected.
- The specified camera number is set to "Unused" in PV500.
- Other number than 01 and 15 is specified.
• A command specifying the camera which has already captured an image
is sent.
% S 9 ,
% S $ 5
Example)
Specify Camera 2:
Bit3 Bit 2
0 1
Specify Cameras 1 and 3:
Bit3 Bit 2
Bit 0
- 1 0
0
BCC CR
0 2 * * CR
2 CR
Bit 1 Bit 0
® aa = 04
0 0
Bit 1 Bit 0
® aa = 10
1 0