Panasonic PV500 User Manual page 224

Error messages when running a test
If Geometry Calculation is not performed properly, error numbers and messages are displayed in the checker
list.
Error No. Message
E0070 Unset item found.
E0071 No ref. checker result.
Error No. Message
E0072 Could not normally calculate.
222
Cause
When a checker to be used is not specified.
When the specified checker did not detect edges, objects or
lines.
Type Cause
Distance When two points are in the same position
Point-Point
Intersecting
• When two lines are parallel and not
Point
intersected
• When the intersection point is out of the
range of +/-9999
Approximate
• When the input point is less than 2
Line
• When all the input points are in the same
position
Approximate
• When the input point is less than 3
Circle
• When the input points are located on a
line
• When the center of the approximate circle
is out of the range of +/-9999
Approximate
• When the input point is less than 6
Ellipse
• When the input points are located on a
line
• When the center of the approximate
ellipse is out of the range of +/-9999
• When the ellipse cannot be calculated
(due to the positions of the input points)