Adjustments When Replacing Parts; Phase Alignment When Installing The Stack Tray Drive Belt; Phase Alignment When Installing The Swing Unit - Canon Staple Finisher-AA1 Service Manual

Adjustments When Replacing Parts

Phase Alignment When Installing the Stack Tray Drive Belt

If you remove or replace the stack tray drive belt, align the phase of the belt installation position.
■ Procedure of Adjustment
1. Align the top surface of the protrusions of the belt holder (front and rear) attached to the stack tray drive belt to the
marks on the support plate, and fix them in place.
• - Clearance: ±2.5 mm or less
Upper part of Protrusion

Phase Alignment When Installing the Swing Unit

If you remove or replace the swing unit, align the phase of the swing unit installation position, and fix them in place.
Mark
Belt Holder (Rear)
Upper part of Protrusion
173
5. Adjustment
Mark
Belt Holder (Front)