Removing The Stack Tray Torque Limiter - Canon Staple Finisher-AA1 Service Manual

1x
2. Remove the escape feed clutch [1].
• 1 shaft support [2]
• 1 connector [3]
1x
■ Handling after parts replacement
1. Clear the parts counter.
(LV1) COPIER > COUNTER > DRBL-2 > ESC-CL
Removing the Stack Tray
Torque Limiter
■ Preparation
1. Remove the rear cover.
" Removing the Rear Cover" on page 94
■ Procedure
1. Remove the torque limiter unit [1].
• 2 screws [2]
[2]
[1]
[1]
[2]
[3]
2x
2. Remove the torque limiter [1].
• 1 E-ring [2] each
• 1 gear [3] each
[3]
NOTE:
Do not loss the parallel pin which remains after removing
the torque limiter.
■ Handling after parts replacement
1. Clear the parts counter.
(LV1) COPIER > COUNTER > DRBL-2 > TRY-TQLM
115
4. Parts Replacement and Cleaning
[1]
[2]
[1]
[2]