Canon Staple Finisher-AA1 Service Manual page 219

2.
Remove the screw when the screw that fixed the
Finisher to the Host Machine is installed.
3.
1x
211
4.
Turn the adjustment dial of the caster in the direction
of the arrow by lifting the dial upward a little to adjust
the tilt.
(A full turn of the adjustment dial changes the height of
the Finisher by 2.0 mm.)
• To tilt the Finisher to the right, turn the dial in the
direction of arrow [A].
• To tiltthe Finisher to the left, turn the dial in the
direction of arrow [B].
NOTE:
Adjust the tilt at 2 left casters.
NOTE:
If the adjustment dial keeps lifting upward, lower the
adjustment dial by releasing three claws. And be sure to
insert the three pins of the adjustment dial to the hole of
the caster support plate.
Claw
7. Installation
Claw
Claw