Adjustments When Replacing Parts Items; Other - Canon Staple Finisher-AA1 Service Manual

No
Adjusting the Sta- Adjusting the Staple-Free Binding Po-
8
ple Position
sition
Adjusting the Saddle Paper End Stop-
9
per Installation Angle
Adjusting the Fold
10 Adjusting the Fold Placement
Position
Adjusting the Saddle Alignment Plate
11
Position
Adjusting the Stitcher Unit Installation
12
Position
Adjusting the Sad-
dle Stitch
13 Adjusting the Saddle Stitch Position

Adjustments When Replacing Parts Items

No Target part
1 Stack Tray Drive Belt
2 Swing Unit
3 Paddle Unit
4 Stapler Unit
5 Paper Folding Roller
6 Stitcher Unit
7 Finisher Controller PCB

Other

No Items
Releasing the Saddle Delivery Tray Stacking
1
Limit
Items
Adjustment item and description
Align the phase of the belt installation position.
Align the phase of the swing unit installation position, and fix them
in place.
Align the phase of the paddle unit installation position.
Adjust the staple position
Align the phase of the paper folding roller installation position.
Adjust the stitcher unit and the stitch positions.
Backup operation before replacement and operation after re-
placement
This is performed when you want to contin-
uously stack over the allowable stacking ca-
pacity when stacking in the saddle delivery
tray.
Use case
When the staple-free binding position in
the staple-free binding mode.
If the fold position of the paper stack deliv-
ered from the saddle stitcher unit is
skewed.
When misalignment occurs in feed direc-
tion.
When misalignment occurs in front/rear di-
rection.
• When the stitch positions of the front
and rear sides become misaligned
• If you remove or replace the stitcher
unit
When the saddle stitch position in the sad-
dle stitch mode.
Use case
147
5. Adjustment
Refer to
"Adjusting the Staple-
Free Binding Position " on
page 161
"Adjusting the Saddle Pa-
per End Stopper Installa-
tion Angle" on page 162
"Adjusting the Fold Place-
ment " on page 164
"Adjusting the Saddle
Alignment Plate Position "
on page 165
"Adjusting the Stitcher
Unit Installation Position "
on page 167
"Adjusting the Saddle
Stitch Position " on page
171
Refer to
"Phase Alignment When Installing the
Stack Tray Drive Belt" on page 173
"Phase Alignment When Installing the
Swing Unit" on page 173
"Phase adjustment of paddle unit" on
page 174
"Phase Alignment When Installing the
Paper Folding Roller" on page 179
" Handling Finisher Controller PCB
Replacements" on page 180
Refer to
"Releasing the Saddle Delivery
Tray Stacking Limit" on page 184