Canon Staple Finisher-AA1 Service Manual page 153

Items
Clearing the parts counter counted by
the finisher controller PCB
Removing the paper dust from the sta-
ple-free binding unit
Clearing the message about the func-
tion limit of the staple-free binding
mode
Adjusting the punch horizontal regis-
tration sensor
Adjustment the punch waste full sensor
Reading the backup data from the
puncher controller PCB
Writing the backup data from the
puncher controller PCB
■ Functional setting items
Items
Setting ON/OFF of the buffer oper-
ation
Setting ON/OFF of the shift sort de-
livery operation for a sheet of paper
Setting the staple timing at the man-
ual staple mode
Setting the delivery number of the
stacking paper at the shift sort mode
Setting the operation of the align-
ment plates at the staple and staple-
free binding mode
Setting the paddle operation when
stacking the paper in the saddle
stitcher unit
Service Mode (SORT-
ER > FUNCTION)
CNT-FCON When clearing the parts counter of the
Finisher.
FR-ST-RP When the performance of the staple-
free binding unit deteriorates.
EMSG-CLR When clearing the message of the limi-
ted function mode related to the staple-
free binding after recovering the finisher
normally.
FN-SENS1 When replacing the horizontal registra-
tion sensor of the puncher unit.
FN-SENS2 - When installing/replacing the puncher
Unit.
- When replacing the punch waste full
sensor.
PUN-BK-R When replacing the puncher controller
PCB.
PUN-BK-W When replacing the puncher controller
PCB.
Service Mode
(SORTER > OP-
TION)
BUFF-SW When the misalignment of the buffered pa-
per stack occurs on the processing tray.
1SHT-SRT Upon user's request.
MSTP-TMG Upon user's request.
SFT-CHNG When improving the stacking alignment dur-
ing the delivery of the stacking paper except
for the paper that is more than 106g/m2 or
tab paper.
STP-ALG When improving the alignment (front/rear)
of the paper at staple and staple-free bind-
ing mode.
SDL-ALG When improving the paper alignment of the
feed direction at stacking the paper in the
saddle stitcher unit.
145
Use case
Use case
5. Adjustment
Remarks
- The part counter value of
the staple-free binding op-
eration increases.
- When the job starts during
the operation of this mode,
the finisher sequence error
jam occurs.
- When the error avoidance
jam occurs during the oper-
ation of this mode, the jam
becomes the error immedi-
ately.
This mode is available when
the puncher unit has been
installed.
This mode is available when
the puncher unit has been
installed.
This mode is available when
the puncher unit has been
installed.
This mode is available when
the puncher unit has been
installed.
Remarks
When the buffer operation is
set to OFF, productivity is de-
creased.
- The stacking condition de-
creases when the collated de-
livery operation for a sheet of
paper enables.
- A sheet of paper is delivered
by non-sort decreases when
the collated delivery operation
for a sheet of paper disables.
The settings of this mode and
the "Settings/Registration"
change at the same time.
When setting to ON, the pro-
ductivity is decreased.
When setting to ON, the pro-
ductivity is decreased.