Overview; Service Mode - Canon Staple Finisher-AA1 Service Manual

Overview

Service Mode

In service mode, the finisher can perform the following adjustment, operation and inspection, and functional setting items.
■ Adjustment items
Items
Adjusting the front 1-staple position
Adjusting the rear 1-staple position
Adjusting the front/rear 2-staple po-
sition
Adjusting the displacement amount
of the buffered paper (1st to 2nd
sheets)
Adjusting the displacement amount
of the buffered paper (2nd to 3rd
sheets)
Adjusting the stitching position of
the saddle stitcher unit
Adjusting the stitching position of
the saddle stitcher unit (thin paper)
Adjusting the folding position of the
saddle stitcher unit
Adjusting the folding position of the
saddle stitcher unit (thin paper)
Adjusting the alignment width of the
saddle stitcher unit
Adjusting the A4 size paper align-
ment position
Adjusting the LTR size paper align-
ment position
Adjusting the center standard posi-
tion of the alignment plates
Adjusting the height of the swing
unit
Adjusting the delivery speed at the
non sort mode
Adjusting the delivery speed at the
shift sort mode
Service Mode
(SORTER > AD-
JUST)
STP-F1 When the front staple position is displaced.
STP-R1 When the rear staple position is displaced.
STP-2P When the front/rear 2-staple position is dis-
placed.
BFF-SFT When the paper displacement occurs on
the 1st to 2nd sheets of buffered paper.
BFF-SFT2 When the paper displacement occurs on
the 2nd to 3rd sheets of buffered paper.
SDL-STP When the stitching position of the saddle
stitcher unit is displaced.
SDL-STP2 When the stitching position of the saddle
stitcher unit is displaced with the thin paper.
SDL-FLD When the folding position of the saddle
stitcher unit is displaced.
SDL-FLD2 When the folding position of the saddle
stitcher unit is displaced with the thin paper.
SDL-ALG When the misalignment occurs within a pa-
per stack on the saddle stitcher unit.
ST-ALG1 When misalignment occurs in A4 size pa-
per.
ST-ALG2 When misalignment occurs in LTR size pa-
per.
CENT-ALG - When the center standard position of the
alignment plates is misaligned.
- When the paper alignment position is dis-
placed.
SW-UP-RL When misalignment occurs by failure of the
paper feeding to the processing tray.
NST-SPD When the paper stacking at non sort mode
is misalignment.
SFT-SPD When the paper stacking on stack tray at
shift sort mode is misalignment.
143
Use case
Do not use this at the normal
service work to influence the
alignment operation greatly.
Adjust the alignment width
with ST-ALG1/ST-ALG2 nor-
mally.
- When the value is decreased,
the productivity is decreased.
- When the buffer operation is
performed, delivery speed
does not change. (The buffer
operation is the operation to
deliver the stacking paper on
the processing tray). The
ON/OFF of buffer operation is
set by BUFF-SW.
5. Adjustment
Remarks