No
Adjusting the
5
Adjusting the Saddle Stitch Position
Saddle Stitch
Adjusting the Paper Alignment
■ Adjusting Stacker Alignment Position
<Use case>
• When misalignment occurs in front/rear direction.
<Procedure of adjustment>
NOTE:
After the setting value is changed, write the changed value in the service label.
1. Adjust the stacker alignment position by the following service modes.
• Adjustment of A4 size paper
SORTER > ADJUST > ST-ALG1
• Adjustment of LTR size paper
SORTER > ADJUST > ST-ALG2
Adjustment range: -50 to 50 (Unit: 0.1mm)
As the value is incremented by 1, the position of the adjustment plate is increased by 0.1mm.
+: Inward (The width of the alignment plates becomes narrow.)
-: Outward (The width of the alignment plates becomes wide.)
2. Enter the setting value, and then press OK key.
Items
Feed Direction
Feed Direction
Use case
When the saddle stitch position in the sad-
dle stitch mode.
Feed Direction
+
-
Alignment Plate
149
5. Adjustment
Refer to
"Adjusting the Saddle Stitch
Position " on page 171