NEC UNIVERGE SV9100 Features And Specifications page 157

Guide to Feature Programming
Program
Program Name/Description
Number
10-09-01 DTMF and Dial Tone Circuit Setup
Allocate the circuits on the GCD-CP10 ETUs
for either DTMF receiving or dial tone detection.
Program 14-01-13 Basic Trunk Data Setup –
Loop Supervision Enable (1) loop supervision
for each trunk that should be able to use Call
Forwarding Off-Premise.
Department Group Pilot Numbers – Dial
11-07-01
Assign pilot numbers to each Department
Group set up.
11-11-01 Service Code Setup (for Setup/Entry
Operation) – Call Forward – All
Assign the Call Forward All Service Code.
11-11-02 Service Code Setup (for Setup/Entry
Operation) – Call Forward – Busy
Assign the Call Forward Busy Service Code.
11-11-03 Service Code Setup (for Setup/Entry
Operation) – Call Forward – No Answer
Assign the Call Forward No Answer Service
Code.
11-11-04 Service Code Setup (for Setup/Entry
Operation) – Call Forward – Busy/No
Answer
Assign the Call Forward Busy No Answer
Service Code.
11-11-05 Service Code Setup (for Setup/Entry
Operation) – Call Forward – Both Ring
Assign the Call Forward Both Ring Service
Code.
Input Data
0 = Common Use
1 = Extension Only
2 = Trunk Only
Dial (maximum of eight digits)
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
157
Default
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
No Setting
841
842
843
844
845