Installing An Rhub Power Cable - Huawei LampSite Installation Manual

LampSite
Installation Guide
Prerequisites
Connectors for an alarm cable are prepared.
Context
Figure 4-36
installation position on both ends of the RHUB cable.
Figure 4-36 RHUB alarm cable
Procedure
Step 1 Connect the RJ45 connector on one end of the alarm cable to the EXT_ALM port on the RHUB.
Step 2 Connect the other end of the alarm cable to the alarm cable port on the device to be monitored.
----End

4.4.9 Installing an RHUB Power Cable

The RHUB power cable provides 110 V AC/220 V AC power supply for the RHUB.
Procedure
Step 1 Route the power cable by referring to
Step 2 Connect the power connector on the X1 end to the AC power input port on the RHUB panel, as
shown in
Step 3 Connect the power connector on the X2 end to the external power supply port, as shown in
Figure
Issue 02 (2014-05-27)
shows the exterior of an RHUB alarm cable.
Figure 4-37.
4-37.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4.4.2 RHUB Cable List
4.4.1 Requirements for Cable
4 Installing an RHUB
shows the
Layout.
39