Table of Contents
Advertisement
LampSite
Installation Guide
Issue 02 (2014-05-27)
Figure 4-19 Removing mounting ears and screws
2.
Use a torque screwdriver or Phillips screwdriver to tighten the four M4×8 screws with
a torque of 1.4 N•m to install the removed mounting ears again, as shown in
4-20. The mounting ears must be aligned with the RHUB panel.
Figure 4-20 Installing mounting ears in standard mode
3.
With one hand holding it, align the mounting holes with the installation holes, slowly
push the RHUB into the required position in the cabinet, as shown in .
4.
Use a torque screwdriver or Phillips screwdriver to tighten the four M6×16 screws
with a torque of 2 N•m, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
4-21.
4 Installing an RHUB
Figure
23
- Quick Links:
- Installing an Rhub
- Installing a Prru
Hide quick links:
Advertisement
Table of Contents
