Huawei LampSite Installation Manual page 63

LampSite
Installation Guide
Figure 5-8 Anchor points of the pRRU installation kits (unit: mm)
(1) Wall
To prevent inhalation or eye contact with dust, take adequate preventive measures when drilling
holes.
Step 3 Use a hammer drill with a φ 8 bit to drill holes at the marked anchor points as shown in as shown
in Figure
distance between them. If they are inaccurately positioned, re-measure and re-drill the holes.
Then, use a rubber mallet to push the two plastic expansion sleeve into the holes.
Issue 02 (2014-05-27)
(2) Plate
CAUTION
5-9. Use the cleaner to clean the dust inside and around the holes and measure the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(3) Anchor point
5 Installing a pRRU
58