Prru Installation Kits - Huawei LampSite Installation Manual

LampSite
Installation Guide

5.4.1 pRRU Installation Kits

This section describes the pRRU installation kits.
Figure 5-6
Figure 5-6 pRRU installation kits
(1) V clamp
(4) Plastic expansion sleeve
The following figure shows the specifications of the installation plate.
Issue 02 (2014-05-27)
NOTE
l The pRRU cannot be grounded. If the pRRU is grounded but the RHUB connected to this pRRU is
not, the pRRU may fail to be powered on.
l A minimum distance of 50 cm must be reserved between the pRRU and the incandescent lamp.
l The installation spacing between the pRRU and the temperature sensor must be greater than 50 cm.
l It is good practice to install the pRRU on materials that can tolerate a temperature higher than 65°C
and have an ignition point higher than 70°C.
shows the exterior of the pRRU installation kits.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(2) Plate
(5) Bolt (M6x80)
5 Installing a pRRU
(3) Screw (M6x50)
(6) Flat washer
56