Huawei LampSite Installation Manual page 52

LampSite
Installation Guide
Installing a pRRU on a wall
When a pRRU is installed on a wall, installation modes vary with the quality of wall, as shown
in Table
Table 5-2 Wall-mounted suggestion
Installation
Mode
Installing the
pRRU on a
wall by drilling
holes
For details, see
5.4.2 pRRU
Installed on a
Wall.
Installing the
pRRU on a
wall using a V
clamp through
an attachment
plate
For details, see
5.4.5 pRRU
Installed on a
Plate.
Issue 02 (2014-05-27)
NOTE
l The pRRU must keep a minimum of 0.5 m away from the power equipment with interference, and
keep a minimum of 2 m away from the source with radiation.
l The pRRU must keep away from a metal wall to avoid the impact on the antenna performance.
5-2.
Requirements
l The wall can bear
a load at least four
times the weight
of a pRRU.
l The screws must
be tightened with
a torque of 10
N·m. This ensures
the screws work
properly and the
wall remains
intact without
cracks in it.
l The wall can bear
a load at least four
times the weight
of a pRRU.
l The thickness of
the wall is less
than the bolt
length (80 mm).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Mounting Brackets
1. Plate
2. Screw (M6X50)
3. Plastic expansion
sleeve
4. Flat washer
1. Plate
2. V clamp
3. Bolt (M6X80)
5 Installing a pRRU
Installation
Diagram
47