Output Mode; How To Change The Direction Of The Motor Rotation - ABB ACS550 User Manual

ACS550 User's Manual

Output mode

In the Output mode, you can:
• monitor actual values of up to three signals in
• change the direction of the motor rotation
• set the speed, frequency or torque reference
• adjust the display contrast
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing
The top right corner of the
display shows the reference
value. The center can be
configured to show up to three
signal values or bar graphs; see
page
selecting and modifying the monitored signals.

How to change the direction of the motor rotation

Step Action
1. If you are not in the Output mode, press
2. If the drive is in remote control (REM shown on the status line), switch to local
control by pressing
the mode and then returns to the Output mode.
3. To change the direction from forward ( shown on the status line) to reverse (
shown on the status line), or vice versa, press
Note: Parameter
50 for instructions on
EXIT
. The display briefly shows a message about changing
LOC
REM
1003 must be set to 3 (
DIRECTION
Group 01: OPERATING DATA
EXIT repeatedly.
LOC 49.1Hz
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00 MENU
repeatedly until you get there.
DIR
.
).
REQUEST
LOC 5.0Hz
HZ 50%
0. 4 A
24. 4 %
DIR 00:00 MENU
Display
REM 49.1Hz
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00 MENU
LOC 49.1Hz
49. 1 Hz
0. 5 A
10. 7 %
DIR MENU
00:00
49.1Hz
LOC
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00 MENU
Control panels
47