ABB ACS550 User Manual page 37

ACS550 User's Manual
After completing a set-up task, the Start-up Assistant suggests the
next one.
• Press OK (when
suggested task.
• Press key
the following task without doing the suggested task.
• Press EXIT to stop the Start-up Assistant.
SAVING A USER PARAMETER SET AND FINAL CHECK
The start-up is now completed. However, it might be useful at this
stage to set the parameters required by your application and save
the settings as a user parameter set as instructed in section
parameter sets
After the whole set-up is completed, check there are no faults or
alarms shown on the display and the panel LED is green and does
not blink.
is highlighted) to continue with the
Continue
to highlight and then press
Skip
on page 81.
The drive is now ready for use.
REM
Do you want to
continue with
application setup?
Continue
Skip
EXIT
OK to move to
User
Start-up, control with I/O and ID Run
37
CHOICE
00:00 OK