Mount The Drive - ABB ACS550 User Manual

ACS550 User's Manual
IP54 / UL type 12
1. If hood is present: Remove screws
(2) holding hood in place.
2. If hood is present: Slide hood up and
off of the cover.
3. Loosen the captive screws around
the edge of the cover.
4. Remove the cover.

Mount the drive

IP21 / UL type 1
1. Position the ACS550 onto the mounting screws or
bolts and securely tighten in all four corners.
Note: Lift the ACS550 by its metal chassis (frame
size R6 by the lifting holes on both sides at the top).
2. Non-English speaking locations: Add a warning
sticker in the appropriate language over the existing
warning on the top of the module.
IP54 / UL type 12
For the IP54 / UL type 12 enclosures, rubber plugs are required in the holes
provided for access to the drive mounting slots.
1. As required for access, remove the rubber plugs.
Push plugs out from the back of the drive.
2. R5 & R6: Align the sheet metal hood (not shown) in
front of the drive's top mounting holes. (Attach as
part of next step.)
3. Position the ACS550 onto the mounting screws or
bolts and securely tighten in all four corners.
Note: Lift the ACS550 by its metal chassis (frame
size R6 by the lifting holes on both sides at the top).
4. Reinstall the rubber plugs.
5. Non-English speaking locations: Add a warning sticker in the appropriate language
over the existing warning on the top of the module.
...
R6 R1 R5
1
2
1
3
2
1, 4
17
4
FM
1
IP2002
3
5
FM
Installation