Chain Dialing; Conference; Data Security; Direct Inward System Access (Disa) - Samsung NX-308 Technical Manual

3feature 1999.9.15 12:44 PM 페이지9
NX-SERIES
HYBRID KEY SYSTEM

CHAIN DIALING

Station users may manually dial additional digits following a Speed-Dial call, or
chain together as many Speed-Dial numbers as required.
CLASS OF SERVICE
System programming may assign any of six outgoing call restriction levels.
Refer to the TOLL RESTRICTION feature.

CONFERENCE

Any combination of up to 5 parties (stations or outside lines) can be joined
together in conference. A station user may also set up the conference with two
or more outside lines and then exit the conference leaving the outside lines
connected in an unsupervised (trunk to trunk) conference. Conferees may be
eliminated or added after a conference has been established.

DATA SECURITY

Single-line stations using modems and facsimile machines can be programmed so that
they will not receive any system-generated tones that would disrupt data transmissions.
DIRECT IN LINES
Outside lines may be programmed to bypass the operator(s) and ring directly at
any station, group of stations, or paging system.

DIRECT INWARD SYSTEM ACCESS (DISA)

Users can call in on specified DISA lines at any time and receive the system dial
tone or pre-programmed voice messages. To make an internal call, dial the station
or station group number. To make an outside call, dial the trunk access code. After
a short beep tone, dial your own station number and station passcode. If the
passcode is correct, the system provides a system dial tone again, and the outside
number may be dialed. Some loss of volume may be experienced in this
configuration. DISA lines can be used as either incoming only or 2-way lines.
MMC 30 STATION TOLL CLASS
MMC 39 DATA LINE
MMC 43 ASSIGN TRUNK RING
MMC 46 ASSIGN DISA LINE
MMC 01 CHANGE STATION PASSCODE
DISA VOICE ANNOUNCEMENT
DISA lines may use pre-programmed voice messages instead of system tones.
Users can access the DISA line normally during the voice announcement.
MMC 42 TRUNK ON/OFF⇒ VOICE MSG (VOICE RECORDING ⇒ 1 8 )
APPENDIX C
3 - 5
FEATURES SECTION