Mmc 80 System I/O Parameters - Samsung NX-308 Technical Manual

4Programming 1999.9.15 12:44 PM 페이지68
NX-SERIES
HYBRID KEY SYSTEM
MMC 80
This MMC provides a means of setting parameters for the serial I/O ports to work with SMDR and
Remote MMC. Programming is accomplished easily with the tables below to customize either I/O port.
PARAMETER
TYPE OF SERVICE
REMOTE STN
BAUD RATE
CHARACTER LENGTH
PARITY
STOP BIT
PROCEDURE
1. Press [TRANSFER] and dial 80
Display Shows
2. Press [VOLUME (-) or (+)] to select the serial port
(COM1, COM2) COM1 and COM2 may be found on
SMDR/R-MMC card. COM1 is SMDR and COM2 is
R-MMC. COM1 is used for SMDR or TRAFFIC port and
COM 2 is used for Remote Programming.
3. Press [REDIAL] or [FLASH] to select the parameters
4. Press [MUTE] or [MESSAGE] to select data
5. Press [TRANSFER] to save and exit
DEFAULT DATA
COM1
COM2
COM1
COM2
SMDR
TRAFFIC
REMOTE
NOTE: "XON OFF" means whether the system checks the CTS pin of the serial
RELATED MMC
NONE
: 9600 8 NONE
: 9600 8 NONE
: XON OFF : ON
: XON OFF : ON
: COM1
: COM1
: COM2 STN : NONE
port or not 'REMOTE STN' means the port displaying the Remote MMC procedure.
PROGRAMMING SECTION
SYSTEM I/O PARAMETERS
OPTIONS
SMDR, REMOTE, TRAFFIC
REMOTE only
300, 600, 1200, 2400, 4800, 9600 BPS
7 BIT, 8 BIT
NONE, EVEN, ODD
1
LCD DISPLAY