Samsung NX-308 Technical Manual page 151

5APPENDIX 1999.9.15 12:41 PM 페이지6
NX-SERIES
HYBRID KEY SYSTEM
open programming and begin the on-site programming session.
NOTE: The header will display CUSTOMER and the name assigned in MMC 81.
2.3 PROGRAMMING PROTOCOL
The NX-SERIES will only recognize keystrokes on the PC keyboard that have
been assigned as NX 24 keyset equivalent. These keystrokes are fixed and are
not programmable. Use the PC equivalent in place of the NX 24 keys as called
for in MMC programming procedures. These keystrokes are described below.
Dial pad numbers may be entered using the number keys of the PC keyboard, or
the number pad on the right side of the PC keyboard (when equipped).
PROGRAM CODE:
WELCOME TO NX SERIES REMOTE PROGRAM
----------------------------------------------------------------
CUSTOMER :
DATE : Sat, 01, Jan
TIME : 00:02
----------------------------------------------------------------
TRANSFER : TAB
SPEAKER : RETURN
UP/DOWN : UP/DOWN
REDIAL/FLASH: LEFT/RIGHT
HOLD : BACKSPACE
APPENDIX A REMOTE PROGRAMMING
5 - 4