Chapter 6: Analyzer Operation
can be TOC, TC, IC, or NPOC depending on what mode the analyzer is set up to run when the conversion
factor is used.)
5.
Press the Save button to save the equation and return to the Factor screen.
6.
Press the Factor Units button and use the alpha/numeric keypad to type the units identifier (up to 10
alpha/numeric characters), such as MG PER L
7.
Press the Save button to save the units and return to the Factor screen.
GE Analytical Instruments ©2016
Figure 54: Configuring the Factor Equation
(Figure
Figure 55: Configuring the Factor Units
148 of 270
55).
DLM 68100-09 EN Rev. A