Table of Contents
Advertisement
Chapter 6: Analyzer Operation
1.
When the User Management feature is enabled, first log in to the InnovOx with the Administrator ID and
password. Otherwise, if the User Management feature is disabled, continue to the next step.
2.
Select the Maintenance tab and press the Conversion Factor button
available conversion factors (Factor 1, Factor 2, Factor 3, Factor 4, and Factor 5).
3.
Press the Factor 1 button (or other Factor button to configure that factor). The Factor screen appears
with configurable Factor Equation, Factor Units and Factor Name buttons
4.
To set up a Conversion Factor equation, press the Factor Equation button and use the keypad to enter
the equation. Use the letter "C" in the equation to represent the raw value produced by the Analyzer. (It
GE Analytical Instruments ©2016
Figure 52: The Maintenance Tab
Figure 53: Configuring a Conversion Factor
147 of 270
(Figure
52) to access the five
(Figure
53).
DLM 68100-09 EN Rev. A
Advertisement
Table of Contents
