Connecting Isdn (S ) Interfaces; Connecting To Isdn Trunk; Connecting To Hicom 300 (Cornet-N) - Siemens Hicom 100 E Service Manual

Installation
Connecting ISDN (S
S0 port
15
16
If the configuration limit for lines is exceeded due to the equipping operation (more than 32
lines), the ports will only be put into operation up to the configuration limit.
If subscriber and trunk lines are combined on an S
bering of the lines since all the module's ports are initially put into operation as lines and
not reconfigured until later.
5.6 Connecting ISDN (S
The Mini-Western sockets of the STLS module are for connection to Euro-ISDN S0 interfaces
1 through 4.
Use S 1 for connection to the public telecommunications system (ISDN trunk).
0
The remaining S interfaces (S
0
trunk or to ISDN terminals (ISDN telephone, group 4 fax machines, PC, automatic dialler) via
an S bus.
0
The connection to Hicom 150E and Hicom 300 (networking with CorNet-N) can also be
established via the S
Hicom 100E S connection options:
0
Point-to-point - PP connection (default)
Point-to-multipoint - PMP connection
5.7

Connecting to ISDN trunk

A Euro-ISDN interface (NT = Network termination) is pre-installed by the network provider.
Plug the connecting cable supplied with the unit into socket S
end into the NT.
5.8

Connecting to Hicom 300 (CorNet-N)

Plug the connecting cable supplied with the unit into socket S
end into the Hicom 300.
5-8
) interfaces
0
Default MSN
60
59
) interfaces
0
2 through S
0
interfaces S 1 through S
0 0
module, there may be gaps in the num-
0
4) can also be used for connection to an ISDN
0
4.
0
1 through S
0
1 through S
0
Hicom 100 E Version 2.1, Service manual
4. Plug the other
0
4. Plug the other
0
A31003-K16-X001-3-7620
,
07/99