System Programming Via Pc; Pc Tool - Siemens Hicom 100 E Service Manual

7.8

System programming via PC

The system can be configured with the aid of PC software under Windows. A serial interface of
the PC is connected to the system's RS232 interface via the serial interface cable (SIC).
With the PC software, the system's customer data memory is read out and processed offline
on the PC. The changed customer data is then transmitted back to the system.
If an error occurs during the transmission, the original contents of the customer data memory
are restored within the system.
7.8.1

PC tool

In addition to clarity and convenient operation, the tool offers the following advantages:
Flexible internal extension numbering.
The assignment of internal extension numbers can be changed directly (maximum of 5 dig-
its). This is not possible using the optiset terminal.
Status display of extensions.
Type of connected terminal, call forwarding and diversion are displayed.
Adjusting internal times in the system.
The values of internal timers in the system are not designed to be altered. However, the
tool is available for doing this in the event of particular problems.
A program-internal copying function (DRAG) allows the convenient transfer of data already
entered.
The contents of the customer data memory can be stored on hard disk or read.
Transfer of the contents of the customer data memory to/from the system by (digital) mo-
dem. (Entry of customer-specific password!) Figure 7-4
Customer data memory update from SW 2.0.1 to SW 2.0.1+ and SW 2.0.2 on the basis of
the new extension number plans.
Flexible service codes.
The assignment of internal codes (e.g. for features) cannot be freely altered using the Op-
tiset terminal.
Querying the SW status of the system and the connected modules.
Querying the HW configuration of the system.
Tool interfaces and help texts in the appropriate languages for the countries supported.
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
Administration and maintenance
System programming via PC
7-43