Provisioning - Cisco SPA112 Administration Manual

Configuring the Voice Settings

Provisioning

Provisioning
Cisco SPA100Series Administration Guide
Field
Key System IP
Address
Force LAN Codec
Use the Voice > Provisioning page to configure profiles and parameters to
provision the ATA from a remote server.
Enter the settings as described below. After making changes, click Submit to
save your settings, or click Cancel to redisplay the page with the saved settings.
Configuration Profile
Field
Provision Enable
Resync On Reset
Resync Random
Delay
Description
The IP address of the Cisco SPA9000.
Default setting: blank
If needed, specify a voice codec.
Default setting: none
Description
Controls all resync actions independently of firmware
upgrade actions. Set to yes to enable remote provisioning.
Default setting: yes
Triggers a resync after every reboot except for reboots
caused by parameter updates and firmware upgrades.
Default setting: yes
The maximum value for a random time interval that the ATA
waits before making its initial contact with the provisioning
server. This delay is effective only on the initial
configuration attempt following power-on or reset. The
delay is a pseudo-random number between zero and this
value.
This parameter is in units of 20 seconds; the default value
of 2 represents 40 seconds. This feature is disabled when
this parameter is set to zero.
This feature can be used to prevent an overload of the
provisioning server when a large number of devices
power-on simultaneously.
Default setting: 2 (40 seconds)
4
61