Cisco SPA112 Administration Manual page 20

Getting Started
Mounting the ATA
WARNING
STEP 1
STEP 2
STEP 3
STEP 4
Cisco SPA100Series Administration Guide
Wall Mounting
The ATA has two wall-mount slots on the bottom panel. To mount the ATA on a wall,
you need mounting hardware (not included). Suggested hardware is illustrated
(not true to scale).
Recommended hardware (not included): Two number-six pan-head tapping
screws, 5/8-in. length, with anchors for sheet rock installation.
5/8 in. (15.8 mm)
Insecure mounting might damage the ATA or cause injury. Cisco is not responsible
for damages incurred by insecure wall-mounting.
To mount the unit to the wall:
Determine where you want to mount the unit. Verify that the surface is smooth, flat,
dry, and sturdy.
Drill two pilot holes into the surface 58 mm apart (about 2.28 in.).
Insert a screw into each hole, leaving a gap of 5 mm (0.1968 in.) between the
underside of each screw head and the surface of the wall.
Place the unit wall-mount slots over the screws and slide the unit down until the
screws fit snugly into the wall-mount slots.
1
19