Cisco SPA112 Administration Manual page 66

Configuring the Voice Settings
Provisioning
Cisco SPA100Series Administration Guide
Firmware Upgrade
NOTE:
Field
Upgrade Enable
Upgrade Error
Retry Delay
Downgrade Rev
Limit
Upgrade Rule
Log Upgrade
Request Msg
Description
Determines whether or not firmware upgrade operations
can occur independently of resync actions.
Default setting: yes
The upgrade retry interval (in seconds) applied in case of
upgrade failure. The ATA has a firmware upgrade error
timer that activates after a failed firmware upgrade
attempt. The timer is initialized with the value in this
parameter. The next firmware upgrade attempt occurs
when this timer counts down to zero.
Default setting: 3600 seconds
Enforces a lower limit on the acceptable version number
during a firmware upgrade or downgrade. The ATA does
not complete a firmware upgrade operation unless the
firmware version is greater than or equal to this parameter.
Default setting: blank
NOTE: The devices with the following PID and TAN
numbers (or later numbers) cannot be downgraded to a
version older than 1.3.3:
• PID—SPA112-BR
• PID—SPA122-BR
• PID—SPA112
• PID—SPA122
• PID—SPA122-RC
This parameter is a firmware upgrade script with the
same syntax as Profile_Rule. Defines upgrade conditions
and associated firmware URLs.
Default setting: blank
Syslog message issued at the start of a firmware upgrade
attempt.
Default setting: $PN $MAC -- Requesting upgrade
$SCHEME://$SERVIP:$PORT$PATH
TAN—74-11115-01 G0
TAN—74-11116-01 F0
TAN—74-9317-02 G0
TAN—74-9318-02 G0
TAN—74-9319-02 G0
4
65