Cisco SPA112 Administration Manual page 69

Configuring the Voice Settings
Regional
Cisco SPA100Series Administration Guide
FreqScript
A mini-script of up to 127 characters that specifics the frequency and level
parameters of a tone.
Syntax: F @L [,F @L
1 1 2 2
Where F F are frequency in Hz (unsigned integers only) and L
–
1 6
corresponding levels in dBm (with up to 1 decimal places) White spaces before
and after the comma are allowed (but not recommended)
Example 1—Call Waiting Tone: 440@-10
Number of Frequencies = 1
Frequency 1 = 440 Hz at –10 dBm
Example 2—Dial Tone: 350@-19,440@-19
Number of Frequencies = 2
Frequency 1 = 350 Hz at –19 dBm
Frequency 2 = 440 Hz at –19 dBm
ToneScript
A mini-script of up to 127 characters that specifies the frequency, level and
cadence parameters of a call progress tone. May contain up to 127 characters.
Syntax: FreqScript;Z
1
The section Z is similar to the S
1
segment is followed by a frequency components parameter: Z
f [,on /off /f [,on /off
i,1 i,2 i,2 i,2 i,3
= n [+n ]+n [+n [+n [+n
1 2 3 4 5
components given in the FreqScript are used in that segment; if more than one
frequency component is used in a segment, the components are summed
together.
Example 1—Dial tone: 350@-19,440@-19;10(*/0/1+2)
Number of Frequencies = 2
Frequency 1 = 350 Hz at –19 dBm
Frequency 2 = 440 Hz at –19 dBm
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 10 s
Number of Segments = 1
Segment 1: On=forever, with Frequencies 1 and 2
Total Tone Length = 10s
Example 2—Stutter tone: 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2)
Number of Frequencies = 2
Frequency 1 = 350 Hz at –19 dBm
Frequency 2 = 440 Hz at –19 dBm
Number of Cadence Sections = 2
[,F @L [,F @L [,F @L
3 3 4 4 5
[;Z ].
2
section in a CadScript except that each on/off
1
/f [,on /off /f
i,3 i,3 i,4 i,4 i,4
]]]]] and 1 < n < 6 indicates which of the frequency
6 k
[,F @L ]]]]
5 6 6
[,on /off /f [,on /off
i,5
i,5 i,5 i,6
4
L are
–
1 6
= D (on /off /
1 1 i,1 i,1
/f ]]]]]), where fi,j
i,6
i,6
68