Honeywell UMC800 Reference Manual page 65

use_rpm 34
sp_rate_dn 35
sp_rate_up 36
FF_GAIN 37
RATIO 39
LBIAS 40
devbar_hi 41
devbar_low 42
L%CO 43
REM_CO 44
FURNACE_F 45
ACTOR
ANTI_SOOT 46
TEMP_LO_LI 48
M
PERCENT_H 50
8/99
BOOL Use minutes (0) or repeats per minute (1) for integral constant
REAL
Set point low rate of change limit, 0 (off) to 99999 (eu/min)
REAL Set point high rate of change limit, 0 (off) to 99999 (eu/min)
REAL Feed forward gain, 0.0 to 10.0
REAL Gain value for Ratio PID (-20 to 20) (default 1) [ used when
RA_BIAS > 0]
REAL Bias value for Ratio PID when RA_BIAS = LOC_BIAS](-99999 to
99999) (0)
REAL High scale value for deviation bar graph (0 to 99999) (default 100)
REAL Low scale value for deviation bar graph [always = -devbar_hi]
REAL Local percent carbon monoxide (2.0 to 35.0, default 20.0)
BOOL Use %CO input instead of local L%CO (default = OFF)
REAL Furnace Factor in %C (-0.5 to 0.5)
BOOL Anti-soot SP limit enable (default = OFF)
REAL
Trigger value for LOTEMP Boolean output (0 to 2500°F)
REAL Percent hydrogen (1 to 100, default = 40)
RS232 Communications Reference Manual
Function Parameter Index Reference
55