Call Feature Settings - Linksys 900 Series Administrator's Manual

Ext 1/2/3/45/6 Tab
Refer-To Target Contact
Sticky 183
Auth INVITE

Call Feature Settings

Field
Blind Attn-Xfer Enable
MOH Server
Message Waiting
Auth Page
Default Ring
Auth Page Realm
Conference Bridge URL
Auth Page Password
Mailbox ID
Voice Mail Server
Linksys 900 Series IP Phone Administrator Guide
5-40
To contact the refer-to target, select yes. Otherwise, select no.
The default is no.
If this feature is enabled, the IP telephony ignores further 180 SIP responses after
receiving the first 183 SIP response for an outbound INVITE. To enable this feature,
select yes. Otherwise, select no.
The default is no.
When enabled, authorization is required for initial incoming INVITE requests from the
SIP proxy.
Description
Enables the 900 Series phone to perform an attended transfer operation by ending the
current call leg and performing a blind transfer of the other call leg. If this feature is
disabled, the 900 Series phone performs an attended transfer operation by referring the
other call leg to the current call leg while maintaining both call legs. To use this feature,
select yes. Otherwise, select no.
The default is no.
User ID or URL of the auto-answering streaming audio server. When only a user ID is
specified, the current or outbound proxy is contacted. Music-on-hold is disabled if the
MOH Server is not specified.
Indicates whether the Message Waiting Indicator on the phone is lit. This parameter is
toggled by a message from the SIP proxy to indicate if a message is waiting.
The default is No.
Specifies whether to authenticate the invite before auto answering a page. The Auto
Answer Page parameter, on the Supplementary Services section of the User tab, is set to
Yes by default.
The default is No.
Type of ring heard. This corresponds to the Ring Tone on the Phone tab.
Identifies the Realm part of the Auth that is accepted when the Auth Page parameter is set
to Yes.
This parameter accepts alphanumeric characters.
This is the URL used to join into a conference call, generally in the form of the word
"conference" or "user@IPaddress:port"
Identifies the password used when the Auth Page parameter is set to Yes.
This parameter accepts alphanumeric characters.
Identifies the voicemail box number/ID for the phone.
Identifies the SpecVM server for the phone, generally the IP address and port number of
the VM server.
Chapter 5 900 Series phone Field Reference
Document Version 3.1