Connecting Your Computer To The Chassis - Cisco Prisma II Installation And Operation Manual

Connecting Your Computer to the Chassis

Introduction
Before you start LCI, you must first connect your computer to the chassis that
contains the module(s) you want to check.
Important: LCI communicates only with those modules located in the chassis to
which your computer is attached. To check other modules, you must connect your
computer to the chassis in which they are located.
Connecting to the Chassis
Follow these steps to connect your computer to the chassis.
1. Plug one end of a nine-pin RS-232 cable into your computer.
2. Plug the other end of the cable into the LCI port. This port is labeled "Local
Craft Interface."
78-739260-01 Rev F Operation Using LCI 4-7