Cisco Prisma II Installation And Operation Manual page 79

Boot Dialog for ICIM/SNMP Configuration,
Changing Parameters
Below is an example dialog where one of the parameters (Trap Community) is
changed. Any of the parameters can be changed, although some should be changed
only with the advice of a Cisco representative.
Note: Parameters that should not be changed are shown in blue.
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface?
This board's LAN IP address(0.0.0.0 = RARP)? [192.133.194.219]
Subnet mask for LAN (0 for none)? [255.255.255.0]
Should there be a default gateway for packet routing?
What is its IP address? [192.133.194.254]
SNMP COMMUNITY STRINGS:
Read Community [public]
Write Community [private]
Trap Community [SNMP_trap]
Trap Port for P2 traps [162]
HARDWARE PARAMETERS:
Baud rate for serial channels [9600]
Enter the Serial number?
HARDWARE PARAMETERS:
Do you want to change the board's Ethernet address?
BOOT ROM PARAMETERS:
IP address of the TFTP Boot server to boot from? [192.133.194.4]
What is the name of the file to be loaded and started? [ram014.crc]
How long (in seconds) should CPU delay before starting up? [5]
Each time a prompt is given, the default value appears in square brackets.
1. Press Enter to retain the current value and move onto the next parameter.
Note: As an example in the above screen, the Trap Community string has
been changed to a new value. The prompt for delay time is the last one before
the summary screen is presented.
2. Press any key repeatedly until the following prompt appears.
Result:
(M)odify any of this or (C)ontinue? [M]
3. Press Enter to get the default value for Modify.
78-739260-01 Rev F
Continued
[Y]
ICIM_Trap
[^AAIIJHC]
Operation Using the ICIM
[Y]
[N]
3-39