Cisco Prisma II Installation And Operation Manual page 107

Modifying Optical Amplifier Alarm Limits,
Result: The Module Details window appears. The alarm limits are shown
under Parameters.
2. Double-click the limit you want to change.
Result: The Change Value dialog box appears. The graphic below shows the
dialog box for the major low limit of the Output Power parameter.
3. In the Command to box, type the value to use for the limit.
4. Click Execute.
Result: The new value appears in the alarm limit column.
Note: For additional information on alarm parameters, see Appendix A, Module
Parameter Descriptions.
4-26
Continued
Operation Using LCI 78-739260-01 Rev F